Nutribullet Replacement Parts nutribullet replacement blade Nutribullet Blender Blade Replacement Nutribullet Replacement Blade 1. For optimal performance, we recommend replacing your extractor blade every 6 months (or sooner, depending on use). 2. Before using the blade, ensure the gasket is snugly in place and check the gear at the bottom. If it's loose, please tighten it for best performance. 3. To clean the blade, we suggest washing it with warm water immediately after use and using a brush for hard-to-reach areas. Avoid washing the blade in the dishwasher. nutribullet blender replacement parts Only compatible with Nutribullet 900 watts and 600 watts blender 600w units number: NBR-0601, NBR-1201, NB-101, NB-101B, NB-101S900w units number: NB9-1301, NB-201 Package Included： 1x Extraction Blade2 x Silicone Rubber GasketNotice: 1 x Silicone Rubber Gasket O Ring pre-installed already in the blade. Nutribullet Replacement Parts Tip for Use: Please check whether the gear of the bottom loosen or tighten before use. If it's loosen, please tighten itPlease check the rubber gasket and be sure it is put snugly into the bottom blade. (The rubber gasket is used to avoiding leakage）Please make sure the blade in right place and locked tightly, replace the gasket if the blender begin leakage.Do not run your blender over 4 minutes at a time to prevent overheating of the blender. Please check your blender regularly and the blade needs to be replaced if there is leakage or loud noise.